Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › GENERATOR (for 130 A Type) › 2015.06–2020.08
RM27T0E _57 Power Source / Network _053727 1GD-FTV BATTERY / CHARGING _0261027 GENERATOR(for 130 A Type) A

1GD-FTV BATTERY / CHARGING  GENERATOR(for 130 A Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

(See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

(See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)


Hide 74481 3.REMOVE BATTERY HOLD DOWN CLAMP

a.
A357172

Loosen the 2 nuts.


b.

Remove the 2 battery clamp bolts and battery hold down clamp.


Hide 28800 4.REMOVE BATTERY

Hide 74431 5.REMOVE BATTERY TRAY

Hide 27060 9.REMOVE GENERATOR ASSEMBLY

a.
A357173

Disconnect the connector from the generator assembly.


b.

Remove the terminal cap.


c.

Remove the nut and disconnect the wire harness from terminal B.


d.

Remove the bolt and disconnect the wire harness from the generator assembly.


e.

Detach the clamp and disconnect the wire harness from the generator bracket.


f.
A357174

Remove the 2 bolts and generator assembly.


g.
A357175

Remove the bolt and generator bracket from the generator assembly.