Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › GENERATOR (for 130 A Type) › 2015.06–2020.08
RM27T0E _57 Power Source / Network _053727 1GD-FTV BATTERY / CHARGING _0261027 GENERATOR(for 130 A Type) A

1GD-FTV BATTERY / CHARGING  GENERATOR(for 130 A Type)  INSTALLATION  


PROCEDURE

Hide 27060 1.INSTALL GENERATOR ASSEMBLY

a.

Install the generator bracket to the generator assembly with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Install the generator assembly with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Attach the clamp and connect the wire harness to the generator bracket.


d.

Connect the wire harness to the generator assembly with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Connect the wire harness to terminal B with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


f.

Install the terminal cap.


g.

Connect the connector to the generator assembly.


Hide 74431 5.INSTALL BATTERY TRAY

Hide 28800 6.INSTALL BATTERY

Hide 74481 7.INSTALL BATTERY HOLD DOWN CLAMP

a.

Install the battery hold down clamp with the 2 nuts and 2 battery clamp bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

(See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)