Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.REMOVE FRONT WHEEL LH
45100
4.REMOVE STEERING WHEEL ASSEMBLY
45287
5.REMOVE STEERING COLUMN LOWER COVER
Remove the 2 screws.
Detach the 2 claws and remove the steering column lower cover.
45286B
6.REMOVE STEERING COLUMN UPPER COVER
Detach the 4 clips.
Detach the claw and remove the steering column upper cover.
7.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Disconnect the connectors from the combination switch with spiral cable.
Use pliers to hold the clamp and raise the claw with a screwdriver. Then remove the combination switch assembly with spiral cable sub-assembly from the steering column assembly.
89783
8.REMOVE TRANSPONDER KEY AMPLIFIER (w/ Transponder Key)
55045
9.REMOVE INSTRUMENT LOWER PANEL FINISH PANEL SUB-ASSEMBLY (w/o Knee Airbag)
73900
10.REMOVE NO. 1 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
45250
11.REMOVE STEERING COLUMN ASSEMBLY
Detach the claws and remove the wire harness protector and wire harness.
Put matchmarks on the steering intermediate shaft and steering column.
| *a | Matchmark |
Remove the bolt.
Remove the 4 nuts and steering column.
53737A
12.REMOVE NO. 1 FRONT FENDER APRON TO FRAME SEAL LH
45220
13.DISCONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
Put matchmarks on the steering intermediate shaft and No. 2 steering intermediate shaft.
| *a | Matchmark |
Remove the bolt, and then pull out the intermediate shaft toward the inside of the vehicle.
45025D
14.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Remove the 4 bolts and steering column hole cover from the vehicle.
45203
15.DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Put matchmarks on the No. 2 steering intermediate shaft and power steering gear.
| *a | Matchmark |
Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.