1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE REAR NO. 1 SEAT ASSEMBLY
for 60/40 Split Double-folding Seat Type LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type LH Side)>REMOVAL).
for 60/40 Split Double-folding Seat Type RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Double-folding Seat Type RH Side)>REMOVAL).
for 60/40 Split Tumble Seat Type LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type LH Side)>REMOVAL).
for 60/40 Split Tumble Seat Type RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)>REMOVAL).
for 60/40 Split Slide Walk-in Seat Type LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)>REMOVAL).
for 60/40 Split Slide Walk-in Seat Type RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)>REMOVAL).
58371F
3.REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
67934
4.REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
67933
5.REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
67918D
6.REMOVE REAR DOOR SCUFF PLATE LH
67917C
7.REMOVE REAR DOOR SCUFF PLATE RH
89839A
8.REMOVE REAR FLOOR SIDE AIRBAG SENSOR COVER
Fold back the floor carpet.
Detach the clip and claw and remove the cover.
89837A
9.REMOVE REAR FLOOR SIDE AIRBAG SENSOR
Remove the bolt and sensor.
Disconnect the connector.