The skid control ECU receives vehicle stability signals from the yaw rate sensor and sends the signals to the driving support ECU and ECM. If the skid control ECU detects that the yaw rate sensor is malfunctioning, the skid control ECU and yaw rate sensor send a malfunction signal to the driving support ECU which stores DTC C1A46.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A46 | While the vehicle speed is 5 km/h (3 mph) or more, a malfunction signal from the skid control ECU and yaw rate sensor is detected for 1 second. | ·
Vehicle stability control system ·
Driving support ECU |
Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).
Vehicle stability control system DTCs are not output.
OK
NG
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
DTC C1A46 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG