Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053736 PRE-CRASH SAFETY _0261101 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A4A  Skid Control Buzzer Circuit  


DESCRIPTION

Based on pre-crash control, the driving support ECU warns the driver to be careful by sending a sounding signal to the skid control ECU to sound the skid control buzzer.

When the skid control ECU detects a malfunction in the skid control buzzer circuit, a malfunction signal is sent to the driving support ECU and a DTC is stored. Although the skid control ECU sends a malfunction signal to the driving support ECU, the relevant ABS DTCs are not stored.

DTC Code DTC Detection Condition Trouble Area
C1A4A While the ignition switch is ON, a skid control buzzer circuit malfunction signal is received by the skid control ECU for 1 second.
·

Skid control buzzer circuit

·

Master cylinder assembly (Skid control ECU)

·

Driving support ECU



PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Select the item below in the Active Test, and then check that the skid control buzzer sounds (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DATA LIST / ACTIVE TEST).

ABS/VSC/TRC
Tester Display Test Part Control Range Diagnostic Note
Buzzer Skid control buzzer ON/OFF -

OK:

Skid control buzzer sounds.




OK

2.REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU)

NG

2.REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU)
a.

for LHD:

Replace the master cylinder solenoid (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for LHD)>DISASSEMBLY).


b.

for RHD:

Replace the master cylinder solenoid (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for RHD)>DISASSEMBLY).



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

OK

END (MASTER CYLINDER SOLENOID [SKID CONTROL ECU] IS DEFECTIVE)

NG