If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU (See page Vehicle Interior>SEAT>REAR POWER SEAT CONTROL SYSTEM>INITIALIZATION).
If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU (See page Vehicle Interior>SEAT>REAR POWER SEAT CONTROL SYSTEM>INITIALIZATION).
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
58410R
1.REMOVE DECK BOARD ASSEMBLY
89715
2.REMOVE FOLD SEAT CONTROL ECU
Disconnect the 2 connectors.
Remove the 2 nuts and ECU.