Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)
RM27T0E _58 Vehicle Interior _053737 SEAT _0261110 FRONT POWER SEAT CONTROL SYSTEM(w/ Memory) J

SEAT  FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)  Wireless-linked Return Function does not Operate  


DESCRIPTION

When a door is unlocked, the certification ECU sends a door unlock signal and key ID signal to the main body ECU (multiplex network body ECU). When the main body ECU (multiplex network body ECU) receives the door unlock signal, it stores the key ID. When the driver door is opened, the memory call and memory command information of the stored key ID is sent to each driving position related control ECU. Each control ECU receives the memory commands and performs the memory call operation according to predetermined control timing values.

CAUTION / NOTICE / HINT

NOTICE:

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this symptom.


PROCEDURE

1.CHECK MEMORY CALL MEMORY FUNCTION
a.

While pressing the M1 switch or M2 switch, press the manual lock or unlock switch. Then check that the buzzer sounds for 0.5 seconds (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)>OPERATION CHECK).

OK:

Buzzer sounds normally.




OK

2.CONFIRM TROUBLE AREAS

NG

GO TO PROBLEM SYMPTOMS TABLE (Wireless Transmitter Memory Function does not Operate)

2.CONFIRM TROUBLE AREAS
a.

Confirm which parts do not operate normally during an automatic memory call operation.

Result
Result Proceed to
Only seat does not operate normally A
Both seat and steering wheel do not operate normally B



A

3.REPLACE FRONT POWER SEAT SWITCH

B

5.REPLACE MAIN BODY ECU
3.REPLACE FRONT POWER SEAT SWITCH
a.

Temporarily replace the front power seat switch with a new or normally functioning one (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY).



NEXT

4.CHECK MEMORY CALL FUNCTION
4.CHECK MEMORY CALL FUNCTION
a.

With a recognition code stored in memory, open the driver door after performing an entry unlock operation or pressing the transmitter unlock switch. Check that the driver side power seat moves to the memorized position (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)>OPERATION CHECK).

OK:

Driver side power seat moves to the memorized position.




OK

END (REPLACE FRONT POWER SEAT SWITCH [DRIVER SIDE])

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

5.REPLACE MAIN BODY ECU
a.

Temporarily replace the main body ECU with a new or normally functioning one (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).



NEXT

6.CHECK MEMORY CALL FUNCTION
6.CHECK MEMORY CALL FUNCTION
a.

With a recognition code stored in memory, open the driver door after performing an entry unlock operation or pressing the transmitter unlock switch. Check that the driver side power seat and steering wheel moves to the memorized position (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)>OPERATION CHECK).

OK:

Driver side power seat and steering wheel moves to the memorized position.




OK

END (REPLACE MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])

NG

REPLACE CERTIFICATION ECU