Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat) › 2015.06–2021.06
RM27T0E _58 Vehicle Interior _053737 SEAT _0261115 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  DISASSEMBLY  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 71706 1.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)

a.
B357440

Detach the 2 hooks and disconnect the 2 rubber bands.


b.
B341419E03
0.349,0.589 0.524,0.745 0.174,0.156 10 *1 2.888,0.589 3.062,0.745 0.174,0.156 10 *1 1.003,0.669 0.544,0.669 false 2.87,0.669 2.412,0.669 false

Apply protective tape to the locations shown in the illustration.

Text in Illustration
*1 Protective Tape


c.
B341416E03
0.347,2.384 0.523,2.544 0.177,0.159 10 *1 2.938,2.337 3.114,2.496 0.177,0.159 10 *1 1.884,3.97 2.060,4.129 0.177,0.159 10 *a 0.738,1.83 0.463,2.371 0.463,2.371 0.768,1.933 false 2.706,1.778 2.981,2.32 2.981,2.32 2.676,1.882 false 1.982,2.939 1.982,3.961 false

Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.

HINT:

Tape the screwdriver tip before use.



d.

Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 front seatback board clips from the front seatback board sub-assembly LH.

Text in Illustration
*1 Protective Tape
*a Point (A)

NOTICE:

Do not reuse the front seatback board clips after removing it.



e.
B247916

Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.


Hide 71706B 2.REMOVE FRONT SEATBACK BOARD CLIP (w/ Seatback Board)

a.
B357441

Remove the 2 front seatback board clips from the separate type front seatback spring assembly.


Hide 84921B 3.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B239530

a.

Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.


Hide 84921A 4.REMOVE RECLINING POWER SEAT SWITCH KNOB

B239532

a.

Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.


Hide 71812D 5.REMOVE FRONT SEAT CUSHION SHIELD LH

a.

Disconnect the lifter motor connector.


b.

Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.


c.

Detach the clip of the front seat No. 1 inner cushion shield LH.


d.

Using a moulding remover, detach the 3 claws and guide.


e.

Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.

B239534


f.
B239536

Detach the 3 claws and open the wire harness cover.


g.

Detach the 3 wire harness clamps and disconnect the seat wire connector.


Hide 84922C 6.REMOVE FRONT POWER SEAT SWITCH LH

a.

Remove the 3 screws.


b.
B239589

w/ Seat Memory System:

Disconnect the 2 power seat switch connectors and remove the front power seat switch LH.


c.
B239537

w/o Seat Memory System:

Disconnect the power seat switch connector and remove the front power seat switch LH.


Hide 84920 7.REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)

Hide 71868A 8.REMOVE FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

B239540

a.

Detach the 2 claws and remove the front seat No. 1 inner cushion shield LH.


Hide 71862 9.REMOVE FRONT SEAT INNER CUSHION SHIELD LH

B239167

a.

Using a moulding remover, detach the 3 claws and remove the front seat inner cushion shield LH.


Hide 71861 10.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)

B239169

a.

Using a moulding remover, detach the 4 claws and remove the front seat inner cushion shield RH.


Hide 73240 11.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

Hide 12.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

a.

w/o Seatback Board:

i.
B239173

Disconnect the rubber band.



b.
B241809

Detach the clamp and disconnect the No. 2 seat wire.


c.
B241810

w/ Seat Heater System:

Disconnect the seat heater connector and detach the seat heater wire harness clamp.


d.
B239177

Detach the 2 hooks.


e.
B239174E01
1.399,3.041 1.579,3.234 0.180,0.193 10 *1 1.601,3.135 1.767,3.135 1.767,3.135 2.519,2.984 false

w/ Front Seat Side Airbag:

i.

Detach the claw and disconnect the airbag connector.


ii.

Detach the 3 airbag wire harness clamps.


iii.

Detach the fastening tape and open the cover.

Text in Illustration
*1 Fastening Tape


iv.

Disconnect the airbag wire harness.



f.
B239178

Remove the 4 bolts and seatback assembly.


Hide 71849 13.REMOVE SEAT ADJUSTER COVER CAP

B239170

a.

Remove the 2 seat adjuster cover caps.


Hide 71149A 14.REMOVE FRONT SEAT LEG COVER LH

B239171

a.

Detach the 2 claws.


b.

Move the front seat leg cover LH in the direction of the arrow to remove it.


Hide 15.REMOVE SEAT CUSHION COVER WITH PAD

a.
B239179

w/ Seat Heater System:

Disconnect the seat heater connector and detach the 3 seat heater wire harness clamps.


b.

Detach the hooks.

B239180


c.
B239181

for Front Passenger Side:

Detach the claw and disconnect the connector.


d.

Remove the seat cushion cover with pad.


Hide 71072S 16.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

a.
B372264

Type A:

i.

Remove the hog rings and disconnect the straps.



b.
B372267E01
2.983,1.387 3.176,1.571 0.193,0.184 10 *1 2.255,1.449 2.948,1.449 false

Type B:

i.

Cut off the tack pins and disconnect the straps.

Text in Illustration
*1 Tack Pin



c.
B239182

Remove the 15 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.


Hide 87510L 17.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)

Hide 71876 18.REMOVE RECLINING ADJUSTER INSIDE COVER LH

B239542

a.

Detach the claw and guide, and then remove the reclining adjuster inside cover LH.


Hide 71874 19.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH

B239543

a.

Remove the screw.


b.

Detach the hook and clip, and then remove the front seat lower cushion shield LH.


Hide 71873 20.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH

a.

Remove the screw.


b.

Detach the hook and clip, and then remove the front seat lower cushion shield RH.


Hide 71537D 21.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH

B239188

a.

Remove the screw.


b.

Move the front seat cushion edge protector LH in the direction of the arrow to detach the hook and remove the front seat cushion edge protector LH.


Hide 71537C 22.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH

HINT:

Use the same procedure described for the LH side.


Hide 85866A 23.REMOVE SEAT CUSHION CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)

a.
B357445

Detach the 2 clamps and 2 claws, and then remove the seat cushion climate control duct LH.


Hide 85860B 24.REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH (w/ Climate Control Seat System)

a.
B357250

Remove the 2 screws and seat cushion climate control bracket.


b.

Disconnect the connector.


c.
B357446

Detach the 2 guides and remove the seat cushion climate control blower assembly LH as shown in the illustration.


Hide 87501B 25.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)

Hide 82192 26.REMOVE FRONT SEAT WIRE LH

a.

Remove the seat wire LH.


Hide 71876A 27.REMOVE RECLINING ADJUSTER INSIDE COVER LH

B239544

a.

Detach the guide and remove the reclining adjuster inside cover LH.


Hide 71875A 28.REMOVE RECLINING ADJUSTER INSIDE COVER RH

a.

Detach the guide and remove the reclining adjuster inside cover RH.


Hide 71074S 29.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

a.

w/o Seatback Board:

i.
B239192

Remove the 3 hog rings.


ii.

Open the 2 fasteners, and then open the seatback cover.

B242232E01
0.93,0.011 1.160,0.204 0.230,0.193 10 *A 4.37,0.011 4.600,0.204 0.230,0.193 10 *B

Text in Illustration
*A for Cloth Seat *B for Leather Seat



b.

w/ Seatback Board:

i.
B357448

Detach the hooks.


ii.
B247933

Remove the 5 hog rings.



c.
B239201

w/ Front Seat Side Airbag:

i.

Remove the nut and seatback cover bracket from the seat frame.


ii.

Disconnect the seatback cover bracket from the separate type front seatback pad.



d.
B239198

Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.


e.
B239205

Remove the 13 hog rings and separate type front seatback cover.


Hide 87510N 30.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)

Hide 71552S 31.REMOVE SEPARATE TYPE FRONT SEATBACK PAD

a.

Remove the separate type front seatback pad.


Hide 85867A 32.REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)

a.
B357248

Disconnect the connector.


b.

Remove the 4 screws and seatback climate control blower LH.


Hide 85866C 33.REMOVE SEATBACK CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)

a.
B357249

Detach the 2 claws and remove the seatback climate control duct LH.


Hide 82168 34.REMOVE NO. 2 SEAT WIRE

a.

for Driver Side:

w/o Climate Control Seat System:

i.
B241803

Disconnect the 2 connectors.


ii.

Detach the 2 clamps and remove the No. 2 seat wire.



b.

for Driver Side:

w/ Climate Control Seat System:

i.
B357451

Disconnect the 2 connectors.


ii.

Detach the 3 clamps and remove the No. 2 seat wire.



c.

for Front Passenger Side:

i.

Disconnect the connector.


ii.

Detach the 2 clamps and remove the seat wire.



Hide 35.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Front Seat Side Airbag)