Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87510L
1.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY LH
Set the seat cushion heater with the name stamp side facing the seat cushion cover.
| *1 | Tack Pin |
| *2 | Seatback Cover |
| *3 | Seatback Heater |
| *4 | Name Stamp |
Install the seat cushion heater with new tack pins.
71072S
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
3.INSTALL SEAT CUSHION COVER WITH PAD
Install the seat cushion cover with pad.
for Front Passenger Side:
Attach the claw to connect the connector.
Attach the hooks.
Connect the seat heater connector and attach the 3 wire harness clamps.
for Clip Type:
Install the 2 clips.
for Hook Type:
Attach the 2 hooks.
w/ Front Seat Side Airbag:
Connect the airbag wire harness.
Attach the fastening tape to close the cover.
Connect the seat heater connector and attach the wire harness clamp.
Install the rubber band to the seat cushion spring.
73240
4.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
for Driver Side:
(See page Vehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>INSTALLATION)
for Front Passenger Side:
(See page Vehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>INSTALLATION)
71862
5.INSTALL FRONT SEAT INNER CUSHION SHIELD LH
71861
6.INSTALL FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
71812D
7.INSTALL FRONT SEAT CUSHION SHIELD LH
72495
8.INSTALL VERTICAL ADJUSTING HANDLE LH (for Driver Side)
72526
9.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
10.INSTALL FRONT SEAT ASSEMBLY
Install the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION).