Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
1.REMOVE FRONT SEAT ASSEMBLY
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Walk in Seat Type)>REMOVAL).
72525B
2.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
71811D
3.REMOVE FRONT SEAT CUSHION SHIELD RH
71861
4.REMOVE FRONT SEAT INNER CUSHION SHIELD RH
73230
5.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH
6.REMOVE SEAT CUSHION COVER WITH PAD
Remove the rubber band from the seat cushion spring.
Disconnect the seat heater connector and detach the wire harness clamp.
w/ Front Seat Side Airbag:
Detach the fastening tape and open the cover.
| *1 | Fastening Tape |
Disconnect the airbag wire harness.
Using a moulding remover, remove the clip.
Detach the hook.
Disconnect the seat heater connector and detach the 3 wire harness clamps.
Detach the hooks.
Detach the claw and disconnect the connector.
Remove the seat cushion cover with pad.
71071S
7.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
87510K
8.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH
Cut off the tack pins and remove the front seat cushion heater from the front seat cushion cover.
| *1 | Tack Pin |