Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67910
2.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
62111C
3.REMOVE COWL SIDE TRIM BOARD RH
55607
4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55317A
5.REMOVE INSTRUMENT SIDE PANEL RH
55461A
6.REMOVE INSTRUMENT PANEL ORNAMENT
55550
7.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
87201B
8.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
82877
9.REMOVE ECU INTEGRATION BOX RH
Disconnect the connectors.
Detach the clamp.
Remove the 2 nuts, bolt and ECU integration box RH.
88650E
10.REMOVE AIR CONDITIONER AMPLIFIER ASSEMBLY
Detach the 2 claws and remove the air conditioner amplifier assembly.