Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
88625Q
1.INSTALL COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
Attach the 2 claws to install the cooler thermistor.
Connect the connector and hose.
83100
2.INSTALL COMBINATION METER ASSEMBLY
55480D
3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55476C
4.INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)
55471A
5.INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).