Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM27T0E _59 Vehicle Exterior _053742 WINDOW / GLASS _0261225 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch  


DESCRIPTION

If the manual up and down function operates normally but the auto up and down function does not, then fail-safe mode may be functioning.

If power window initialization has not been performed, the auto up and down function will not operate (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).

WIRING DIAGRAM

B385746E01
0.677,2.458 4.344,2.656 3.667,0.198 10 false : LIN Communication Line 0.667,0.76 2.354,0.958 1.688,0.198 10 false M10*1, L3*2 0.667,0.927 6.781,1.125 6.115,0.198 10 false Multiplex Network Master Switch Assembly 0.156,1.563 1.844,1.76 1.688,0.198 10 false *1: for LHD 0.167,1.906 1.854,2.104 1.688,0.198 10 false *2: for RHD 2.542,0.427 3.156,0.625 0.615,0.198 10 false LIN1 4.344,0.438 4.958,0.635 0.615,0.198 10 false LIN 4.063,0.958 5.969,1.365 1.906,0.406 10 false Front Power Window Regulator Motor Assembly LH*1 4.063,0.771 5.75,0.969 1.688,0.198 10 false M2*1, L2*2 4.083,1.635 5.99,1.979 1.906,0.344 10 false Front Power Window Regulator Motor Assembly RH*2 2.948,0.26 3.563,0.458 0.615,0.198 10 false 17 4.083,0.271 4.698,0.469 0.615,0.198 10 false 9

CAUTION / NOTICE / HINT

NOTICE:
·

The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

·

If the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).

·

Check that the "D Window Auto Up" and "D Window Auto Down" power window control system customize settings are "ON" before proceeding with work (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>CUSTOMIZE PARAMETERS).

·

After the catch protection function operates, the auto operation is not performed the first time auto up is performed. All auto up operations performed after the first operate normally.



HINT:

If the pulse sensor built into the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) is malfunctioning, the power window control system enters fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the multiplex network master switch assembly at the auto up position, and opened manually by pushing down the multiplex network master switch assembly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>FAIL-SAFE CHART).


PROCEDURE

1.READ VALUE USING GTS (MASTER SWITCH)
a.

Read the Data List according to the display on the GTS (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Master Switch
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door P/W Auto SW Driver door power window auto switch signal / OFF or ON OFF: Driver door power window auto switch not being operated
ON: Driver door power window auto switch being operated
-

OK:

On the GTS screen, ON or OFF is displayed accordingly.




OK

2.READ VALUE USING GTS (D-DOOR MOTOR)

NG

REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

2.READ VALUE USING GTS (D-DOOR MOTOR)
a.

Read the Data List according to the display on the GTS (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

D-Door Motor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door P/W Auto SW Driver door power window auto switch signal / OFF or ON OFF: Driver door power window auto switch not being operated
ON: Driver door power window auto switch being operated
-

OK:

On the GTS screen, ON or OFF is displayed accordingly.




OK

3.PERFORM INITIALIZATION (FOR DRIVER DOOR)

NG

5.REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
3.PERFORM INITIALIZATION (FOR DRIVER DOOR)
a.

Initialize the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



NEXT

4.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION)
4.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION)
a.

Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly is operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Driver door auto up and down function is normal.


Result
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

END (PROBLEM DUE TO INITIALIZATION FAILURE)

B

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

5.REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
a.

Replace the multiplex network master switch assembly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL).



NEXT

6.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION)
6.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION)
a.

Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly is operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

Result
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

END (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WAS DEFECTIVE)

B

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH