Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
69298C
2.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
74611C
3.REMOVE ASSIST GRIP COVER LH
67604
4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
68174A
5.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
86160C
6.REMOVE REAR SPEAKER SET
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER
68152C
8.REMOVE REAR DOOR GLASS RUN LH
67408E
9.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68124B
10.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
68104
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
69840A
12.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY LH
85720C
13.REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor.