This circuit detects the conditions (on or off) of the headlight cleaner switch assembly.
Remove the headlight cleaner switch assembly (See page Vehicle Exterior>WIPER / WASHER>HEADLIGHT CLEANER SWITCH>INSPECTION).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 - 8 | Headlight cleaner switch on | Below 1 Ω |
| 5 - 8 | Headlight cleaner switch off | 10 kΩ or higher |
OK
NG
Disconnect the G72 headlight cleaner switch connector.
Disconnect the A38 headlight cleaner control relay connector.
Remove the main body ECU (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G72-8 - A38-2 | Always | Below 1 Ω |
| G72-5 - A-15 (HRLY) | Always | Below 1 Ω |
| G72-8 - Body ground | Always | 10 kΩ or higher |
| G72-5 - Body ground | Always | 10 kΩ or higher |
OK
NG