Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL HEADLIGHT ASSEMBLY LH
Put protective tape around the headlight assembly LH.
Connect each connector.
Install the headlight assembly LH with the bolt and 3 screws.
| *1 | Protective Tape | *2 | Bolt |
| *3 | Screw | - | - |
Install the clip.
53828J
2.INSTALL FRONT FENDER SIDE PANEL PROTECTOR LH
Attach the 3 clips to install the front fender side panel protector LH.
52119A
3.INSTALL FRONT BUMPER COVER
4.ADJUST HEADLIGHT AIMING
5.ADJUST FOG LIGHT AIMING