A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
52103
1.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH
Install the front bumper bracket sub-assembly LH with the 2 bolts.
52102
2.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
81150
3.INSTALL HEADLIGHT ASSEMBLY LH
for Halogen Headlight:
(See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight)>INSTALLATION)
for LED Headlight:
(See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for LED Headlight)>INSTALLATION)
81110
4.INSTALL HEADLIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52521
5.INSTALL FRONT BUMPER CENTER UPPER RETAINER
Install the front bumper center upper retainer with the 3 bolts.
52116A
6.INSTALL FRONT BUMPER SIDE SUPPORT LH
Attach the 2 claws to install the front bumper side support LH.
Install the screw and bolt.
52115A
7.INSTALL FRONT BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52026B
8.INSTALL FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY LH
Install the front bumper No. 2 extension sub-assembly LH with the 4 bolts.
52025B
9.INSTALL FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
52021
10.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Install the front bumper reinforcement sub-assembly with the 6 nuts.
52129B
11.INSTALL FRONT BUMPER LOWER COVER
Install the front bumper lower cover with the 5 bolts.
Install the clip.
52611
12.INSTALL FRONT BUMPER ENERGY ABSORBER
Install the front bumper energy absorber.
52119A
13.INSTALL FRONT BUMPER COVER
w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 3 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
Connect the connector.
w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
Connect the 2 connectors.
w/ Headlight Cleaner System:
Connect the No. 1 headlight cleaner hose.
Attach the 16 claws to install the front bumper cover.
Do not hold the middle of the front bumper cover, as it may become reformed.
Install the 4 clips.
Install the 2 bolts labeled A and 2 bolts labeled B.
| *1 | Screw |
| *2 | Bolt A |
| *3 | Bolt B |
Install the 2 screws.
Install the 2 screws.
Use the same procedure for the screws on the other side.
53111
14.INSTALL RADIATOR GRILLE
53292A
15.INSTALL UPPER RADIATOR SUPPORT SEAL
16.ADJUST FOG LIGHT AIMING (w/ Fog Light)
17.CHECK TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ TOYOTA Parking Assist-sensor System)