Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Window Frame Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or window frame moulding excessively.
75762A
1.INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING LH
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body surface.
Wipe off any tape adhesive residue with cleaner.
Install a new rear door front window frame moulding.
Using a heat light, heat a new rear door front window frame moulding and the vehicle body surface.
Remove the peeling paper from the face of the rear door front window frame moulding.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the clip and double-sided tape to install the rear door front window frame moulding.
Press the rear door front window frame moulding firmly to install it.
Install a new door window frame moulding clip.
67872
2.INSTALL REAR DOOR WEATHERSTRIP LH
Attach the clip to install the upper part of the rear door weatherstrip.
75722A
3.INSTALL REAR DOOR BELT MOULDING LH
68104
4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
68124B
5.INSTALL REAR DOOR QUARTER WINDOW GLASS LH
67408E
6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68152C
7.INSTALL REAR DOOR GLASS RUN LH
67842E
8.INSTALL REAR DOOR SERVICE HOLE COVER LH
68174A
9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
67604
10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
74611C
11.INSTALL ASSIST GRIP COVER LH
69298C
12.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).