Use these procedures to troubleshoot the rear view monitor system.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Navigation System (for Navigation Receiver Type).
Refer to Audio and Visual System (for Radio andDisplay Type).
| Result | Proceed to |
|---|---|
| Navigation system or Audio and visual system is normal | A |
| Navigation system is abnormal (for Navigation Receiver Type) | B |
| Audio and visual system is abnormal (for Radio and Display Type) | C |
A
B
C
Use the GTS to check if the CAN communication system is functioning normally.
for LHD with Entry and Start System:Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for LHD without Entry and Start System:Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD with Entry and Start System:Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD without Entry and Start System:Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Entry and Start System)>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD with Entry and Start System) | B |
| CAN DTC is output (for LHD without Entry and Start System) | C |
| CAN DTC is output (for RHD with Entry and Start System) | D |
| CAN DTC is output (for RHD without Entry and Start System) | E |
A
B
C
D
E
Check for DTCs and note any codes that are output.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIDE MONITOR SYSTEM>DTC CHECK / CLEAR
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIDE MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.Try to prompt the DTC by simulating the original activity that the DTC suggests.
The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
| System | Proceed to |
|---|---|
| Parking Assist Monitor System | ( )
|
| Wide View Front Monitor System | ( )
|
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to the Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Terminals of ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT