Use the following procedure to troubleshoot the air conditioning system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Inspect the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD with Entry and Start System) | B |
| CAN DTC is output (for LHD without Entry and Start System) | C |
| CAN DTC is output (for RHD with Entry and Start System) | D |
| CAN DTC is output (for RHD without Entry and Start System) | E |
A
B
C
D
E
Check panel diagnosis.
Indicator Check
Sensor Check
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and note any codes that are output.
Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC. Then recheck for DTCs
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Data List / Active Test
On-vehicle Inspection
Inspection
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |