Use the following procedure to troubleshoot the air conditioning system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Inspect the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and note any codes that are output.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMBUSTION TYPE POWER HEATER SYSTEM>DIAGNOSIS SYSTEM
Clear the DTCs.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMBUSTION TYPE POWER HEATER SYSTEM>DIAGNOSIS SYSTEM
Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the conditions indicated by the DTC. Then recheck for DTCs
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Terminals of ECU
Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMBUSTION TYPE POWER HEATER SYSTEM>TERMINALS OF ECU
On-vehicle Inspection
Inspection
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |