Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053731 THEFT DETERRENT / KEYLESS ENTRY _0261055 ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System) Y

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/ Entry and Start System)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use this procedure to troubleshoot the engine immobiliser system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
3.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the LIN communication system is functioning normally.

Result:
Result Proceed to
LIN DTC is not output A
LIN DTC is output B




A

4.CHECK FOR DTC*

B

4.CHECK FOR DTC*


c.

Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same ECD system*1, SFI system*2, steering lock system or engine immobiliser system DTC by reproducing the symptoms indicated by the DTC.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)>DTC CHECK / CLEAR

*1: for Diesel

*2: for Gasoline



Result:
Result Proceed to
DTC is not output A
SFI system DTC is output (for 2TR-FE) B
SFI system DTC is output (for 1GR-FE) C
ECD system is output (for 1KD-FTV) D
ECD system is output (for 1GD-FTV (w/ Urea SCR System)) E
ECD system is output (for 1GD-FTV) F
Steering lock system DTC is output G
Engine immobiliser system DTC is output H



A

5.PROBLEM SYMPTOMS TABLE

B

C

D

E

F

G

H

5.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B




A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
HINT:

If the certification ECU (smart key ECU assembly), ID code box (immobiliser code ECU), steering lock ECU (steering lock actuator assembly), main body ECU (multiplex network body ECU), ECM, or electrical key transmitter sub-assembly are replaced, refer to Service Bulletin.


Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END