Use these procedures to troubleshoot the tire pressure warning system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the engine switch ON.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Set the pressure of each tire to the specified value.
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
Make sure the tires are cooled down when adjusting the tire pressure.
Display "ID Tire Inflation Pressure" in the Data List and check that tire pressure data matches the adjusted tire pressure.
It takes a few minutes to display the updated tire pressure data.
Perform initialization.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION
The warning threshold value changes depending on the driving conditions during initialization. As a result, the tire pressure warning light may not turn off even if the tire pressure is adjusted to the specified pressure.
| Result | Proceed to |
|---|---|
| Tire pressure warning light remains on | A |
| Tire pressure warning light goes off | B |
A
B
Check for DTCs.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
Refer to the Diagnostic Trouble Code Chart.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Problem Symptoms Table.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Electronic Circuit Inspection Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Repair or replace parts based on the diagnosis result.
| Proceed to |
|---|
| NEXT |
NEXT
Check the Data List to confirm that the tire inflation pressure has been received.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
Perform initialization.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION
Confirm that the initialization has been completed.
| Proceed to |
|---|
| NEXT |
NEXT