The radio and display receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.
Using this circuit, the radio and display receiver assembly sends power to the telephone microphone assembly, and the telephone microphone assembly sends microphone signals to the radio and display receiver assembly.
The radio and display receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.
Using this circuit, the telematics transceiver sends power to the telephone microphone assembly, and the telephone microphone assembly sends microphone signals to the radio and display receiver assembly via the telematics transceiver.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Choose the model to be inspected.
| Model | Proceed to |
|---|---|
| w/o Telematics Transceiver | A |
| w/ Telematics Transceiver | B |
A
B
Disconnect the H51 radio and display receiver assembly connector.
Disconnect the W7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H51-6 (SNS2) - W7-14 (SNS2) | Always | Below 1 Ω |
| H51-4 (MACC) - W7-11 (MACC) | Always | Below 1 Ω |
| H51-5 (MIN+) - W7-12 (MCO+) | Always | Below 1 Ω |
| H51-19 (MIN-) - W7-13 (MCO-) | Always | Below 1 Ω |
| H51-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| H51-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| H51-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| H51-18 (SGND) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(for Front)>REMOVAL
Remove the telephone microphone assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-11 (MACC) - B-5 (MACC) | Always | Below 1 Ω |
| A-12 (MCO+) - B-3 (MIC+) | Always | Below 1 Ω |
| A-13 (MCO-) - B-2 (MIC-) | Always | Below 1 Ω |
| A-14 (SNS2) - B-1 (SNS2) | Always | Below 1 Ω |
| A-11 (MACC) - A-12 (MCO+) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-13 (MCO-) - A-14 (SNS2) | Always | 10 kΩ or higher |
OK
NG
Replace the telephone microphone assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL).
Check that the malfunction disappears.
Malfunction disappears.
OK
NG
Disconnect the H51 radio and display receiver assembly connector.
Disconnect the W7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H51-6 (SNS2) - W7-14 (SNS2) | Always | Below 1 Ω |
OK
NG
Disconnect the H51 radio and display receiver assembly connector.
Disconnect the G187 telematics transceiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H51-5 (MIN+) - G187-18 (MCO+) | Always | Below 1 Ω |
| H51-19 (MIN-) - G187-19 (MCO-) | Always | Below 1 Ω |
| H51-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| H51-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| H51-18 (SGND) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the G187 telematics transceiver connector.
Disconnect the W7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G187-33 (MCVD) - W7-11 (MACC) | Always | Below 1 Ω |
| G187-34 (MCI+) - W7-12 (MCO+) | Always | Below 1 Ω |
| G187-35 (MCI-) - W7-13 (MCO-) | Always | Below 1 Ω |
| G187-33 (MCVD) - Body ground | Always | 10 kΩ or higher |
| G187-34 (MCI+) - Body ground | Always | 10 kΩ or higher |
| G187-35 (MCI-) - Body ground | Always | 10 kΩ or higher |
| G187-32 (SGND) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(for Front)>REMOVAL
Remove the telephone microphone assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-11 (MACC) - B-5 (MACC) | Always | Below 1 Ω |
| A-12 (MCO+) - B-3 (MIC+) | Always | Below 1 Ω |
| A-13 (MCO-) - B-2 (MIC-) | Always | Below 1 Ω |
| A-14 (SNS2) - B-1 (SNS2) | Always | Below 1 Ω |
| A-11 (MACC) - A-12 (MCO+) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-11 (MACC) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-13 (MCO-) | Always | 10 kΩ or higher |
| A-12 (MCO+) - A-14 (SNS2) | Always | 10 kΩ or higher |
| A-13 (MCO-) - A-14 (SNS2) | Always | 10 kΩ or higher |
OK
NG
| *a | Component with harness connected
(Telematics Transceiver) |
Disconnect the W7 map light assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G187-33 (MCVD) - Body ground | Ignition switch ACC | 4 to 6 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G187-32 (SGND) - Body ground | Always | Below 1 Ω |
| G187-35 (MCI-) - Body ground | Always | Below 1 Ω |
OK
NG
Replace the telephone microphone assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL
Check that the malfunction disappears.
Malfunction disappears.
OK
NG