Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › EXHAUST FUEL ADDITION INJECTOR › 2016.08–2018.06
RM27T0E _51 Engine / Hybrid System _053675 1GD-FTV EMISSION CONTROL _0260624 EXHAUST FUEL ADDITION INJECTOR A

1GD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR  INSTALLATION  


PROCEDURE

Hide 23710B 1.INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

a.

Install a new No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring, O-ring and No. 3 fuel injector back-up ring to the exhaust fuel addition injector assembly.


b.

Install a new E-ring to the exhaust fuel addition injector assembly.


c.

Install a new gasket and the exhaust fuel addition injector assembly to the No. 1 injector holder.


Hide 23695B 2.INSTALL NO. 2 NOZZLE HOLDER CLAMP

a.

Using a T40 "TORX" socket wrench, install the No. 2 nozzle holder clamp with the bolt.

Torque:
12 N*m (117 kgf*cm, 8 ft.*lbf)


Hide 23295C 3.INSTALL INJECTOR HOLDER

a.

Install the injector holder to the No. 1 injector holder with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 17168 4.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.

Install a new gasket and the No. 2 exhaust manifold heat insulator to the No. 1 injector holder with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 23295D 5.INSTALL NO. 1 INJECTOR HOLDER

a.

Install the No. 1 injector holder to the exhaust manifold with 3 new nuts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


b.

Connect the connector to the exhaust fuel addition injector assembly.


Hide 16282 6.CONNECT NO. 5 WATER BY-PASS HOSE

a.

Connect the No. 5 water by-pass hose to the No. 1 injector holder, and slide the clamp to secure the hose.


Hide 16281 7.CONNECT NO. 4 WATER BY-PASS HOSE

a.

Connect the No. 4 water by-pass hose to the No. 1 injector holder, and slide the clamp to secure the hose.


Hide 23811H 9.INSTALL NO. 1 FUEL PIPE

a.

Connect the No. 1 fuel pipe to the No. 4 fuel pipe.


b.

Install a new gasket and the No. 1 fuel pipe to the cylinder head cover sub-assembly and No. 1 injector holder with the union bolt and bolt.

Torque:
for bolt : 10 N*m (102 kgf*cm, 7 ft.*lbf)
for union bolt : 36 N*m (367 kgf*cm, 27 ft.*lbf)