Use these procedures to troubleshoot the entry and start system (for Entry Function).
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the batterybefore proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD with Entry and Start System) | B |
| CAN DTC is output (for RHD with Entry and Start System) | C |
A
B
C
Use the intelligent tester to check if the LIN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| LIN DTC is not output | A |
| LIN DTC is output | B |
A
B
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check for DTCs. Based on the DTCs output, try to cause the same steering lock system DTC, engine immobiliser system DTC or entry and start system (for Entry Function) DTC to be stored by reproducing the symptoms indicated by the DTC.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| Steering lock system DTC is output | B |
| Engine immobiliser system DTC is output | C |
| Entry and start system (for Entry Function) DTC is output | D |
A
B
C
D
Refer to the Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT