Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Urea SCR System) › 2016.08–2017.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260461 ECD SYSTEM(w/ Urea SCR System) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  P2200  NOx Sensor Circuit Bank 1 Sensor 1  P220E  NOx Sensor Heater Control Circuit Range/Performance Bank 1 Sensor 1  


DESCRIPTION

An nitrogen oxides sensor is installed in front exhaust pipe assembly, in order to detects the concentration of NOx and O2 in the exhaust gas.

P2200
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Engine switch on (IG) for 3 seconds or more An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more.
(2 tripdetection logic)
Nitrogen oxides sensor

P220E
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Engine switch on (IG) for 3 seconds or more An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more.
(2 tripdetection logic)
Nitrogen oxides sensor

Related Data List
DTC No. Data List
P2200
P220E
NOx Density B1S1

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


d.

Read the DTCs.


Result
Result Proceed to
DTC P2200, P220E is output A
DTC P2200 or P220E and other DTCs are output* B

HINT:

*: If any other DTCs are output, perform troubleshooting for those DTCs first.



A

2.REPLACE NITROGEN OXIDES SENSOR

B

2.REPLACE NITROGEN OXIDES SENSOR
a.


NEXT

3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.



d.

Engine switch on (IG) for 3 seconds or more.


e.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


f.

Confirm that the DTC is not output again.



NEXT

END