Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67910
3.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
62111C
4.REMOVE COWL SIDE TRIM BOARD RH
55317A
5.REMOVE INSTRUMENT SIDE PANEL RH
55461A
6.REMOVE INSTRUMENT PANEL ORNAMENT
55607
7.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55550
8.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
89533
9.REMOVE 4 WHEEL DRIVE CONTROL ECU
Disconnect the 2 connectors.
Remove the bolt and 4 wheel drive control ECU.