The combination meter assembly receives the hazard warning signal switch assembly ON signal and controls the operation of the hazard warning lights.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not
Using the GTS, read the Data List.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item / Range | Control Range | Diagnostic Note |
|---|---|---|---|
| Hazard Flasher Switch | Integration control and panel assembly (hazard warning signal switch) / OFF or ON | OFF: Integration control and panel assembly (hazard warning signal switch) off
ON: Integration control and panel assembly (hazard warning signal switch) on |
- |
Normal condition listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>PROBLEM SYMPTOMS TABLE
NG
Remove the integration control and panel assembly (hazard warning signal switch).
Click hereVehicle Exterior>LIGHTING (EXT)>HAZARD WARNING SWITCH>REMOVAL
Inspect the integration control and panel assembly (hazard warning signal switch).
Click hereVehicle Exterior>LIGHTING (EXT)>HAZARD WARNING SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G23 hazard warning signal switch assembly connector.
Disconnect the G304 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G23-8 (HAZ) - G304-7 (HZSW) | Always | Below 1 Ω |
| G23-4 (GND) - Body ground | Always | Below 1 Ω |
| G23-8 (HAZ) or G304-7 (HZSW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG