Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING (w/ Air Suspension)
Install the coil spring to the vehicle body with the lower end of the coil spring facing the rear side of the vehicle.
| *a | Lower End |
| *b | Outer Side |
| *c | Rear Side |
Install the 3 nuts to the top of the front shock absorber with coil spring.
Temporarily install the bolt, washer and nut as shown in the illustration.
Using SST, install the bracket with the nut.
Using a 4 mm hexagon wrench, install the absorber control actuator with the 2 bolts.
Attach the 3 clamps and connect the connector.
2.TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING (w/o Air Suspension)
Install the coil spring to the vehicle body with the lower end of the coil spring facing the rear side of the vehicle.
| *a | Lower End |
| *b | Outer Side |
| *c | Rear Side |
Install the 3 nuts to the upper side of the front shock absorber with coil spring.
Temporarily install the bolt, washer and nut as shown in the illustration.
48626
3.CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH
Connect the front lower ball joint attachment with the 2 bolts.
48811
4.INSTALL FRONT STABILIZER BAR (w/ KDSS)
5.INSTALL FRONT STABILIZER END BRACKET (w/ KDSS)
48811
6.INSTALL FRONT STABILIZER BAR (w/o KDSS)
48829A
7.INSTALL FRONT NO. 1 STABILIZER BRACKET LH (w/o KDSS)
48824A
8.INSTALL FRONT NO. 1 STABILIZER BRACKET RH (w/o KDSS)
48810
9.CONNECT FRONT STABILIZER LINK ASSEMBLY LH (w/o KDSS)
Connect the stabilizer link to the steering knuckle with the nut.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
48820B
10.CONNECT FRONT STABILIZER LINK ASSEMBLY RH (w/o KDSS)
Use the same procedure described for the LH side.
11.INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY
51405A
12.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
52129B
13.INSTALL LOWER FRONT BUMPER COVER
14.INSTALL FRONT WHEEL
15.STABILIZE SUSPENSION
Lower the vehicle.
Bounce the vehicle up and down several times to stabilize the suspension.
16.TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING
Tighten the nut.
17.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Inspect and adjust the front wheel alignment (See page Suspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT).