This DTC is stored when a communication error occurs between the radio and display receiver assembly and combination meter assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1324 | After the radio and display receiver assembly receives a registration information signal, which is sent by the combination meter assembly when the engine switch is on (ACC), 1 or more times, the radio and display receiver assembly does not receive the signal for 30 seconds or more. | ·
Combination meter assembly ·
Radio and display receiver assembly ·
Harness or connector |
Disconnect the H50 radio and display receiver assembly connector.
Disconnect the G304 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H50-3 (CNH1) - G304-37 (MSCL) | Always | Below 1 Ω |
| H50-4 (CNL1) - G304-38 (MSCH) | Always | Below 1 Ω |
| H50-3 (CNH1) - Body ground | Always | 10 kΩ or higher |
| H50-4 (CNL1) - Body ground | Always | 10 kΩ or higher |
| H50-3 (CNH1) - H50-4 (CNL1) | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H50-3 (CNH1) - Body ground | Always | Below 1 V |
| H50-4 (CNL1) - Body ground | Always | Below 1 V |
OK
NG
Remove the combination meter assembly (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 37 (MSCL) - 38 (MSCH) | Always | 108 to 132 Ω |
OK
NG
Remove the radio and display receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (CNH1) - 4 (CNL1) | Always | 108 to 132 Ω |
OK
NG
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL)
Replace the combination meter assembly with a new one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL)
Turn the engine switch on (IG) and wait 30 seconds.
Operate the steering pad switch assembly and check that the audio tab is displayed on the multi-information display in the combination meter assembly and the audio system can be operated normally.
Audio system returns to normal.
OK
NG
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL)