When the transfer shift actuator assembly is switching between high (H4*1, H4F or H4L*2) and low (L4*, L4L*2), the HL1 and HL2 terminals are in one of the ON/OFF combinations listed in the table below.
*1: for 1GR-FE, 1GD-FTV or 1KD-FTV
*2: for 2TR-FE or 5L-E
| Terminal | Mode | ||
|---|---|---|---|
| HIGH (H4*1, H4F or H4L*2) | Switching | LOW (L4*1, L4L*2) | |
| HL1 | OFF | ON | ON |
| HL2 | ON | ON | OFF |
*1: for 1GR-FE, 1GD-FTV or 1KD-FTV
*2: for 2TR-FE or 5L-E
A malfunction is detected depending on the combination of the 2 circuits that make up the high-low transfer limit switch.
| DTC No. | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| P17AC | 1.
When switching between high and low (high-low transfer shift motor operating) while the ignition switch is turned to ON or directly after the ignition switch is turned to ON 2.
The combination of HL1 and HL2 does not match 3.
0.05 seconds or more (if directly after ignition switch is turned to ON, 1 second or more) 4.
1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Transfer shift actuator assembly |
Disconnect the G53 4 wheel drive control ECU connector.
Disconnect the C43 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G53-8 (HL1) - C43-12 (HL1) | Always | Below 1 Ω |
| G53-7 (HL2) - C43-11 (HL2) | Always | Below 1 Ω |
| C43-6 (GND1) - Body ground | Always | Below 1 Ω |
| G53-8 (HL1) or C43-12 (HL1) - Body ground | Always | 10 kΩ or higher |
| G53-7 (HL2) or C43-11 (HL2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the C43 transfer shift actuator assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| C43-12 (HL1) - Body ground | Ignition switch ON | 10.5 to 14 V |
| C43-11 (HL2) - Body ground | Ignition switch ON | 10.5 to 14 V |
| *a | Front view of wire harness connector
(to Transfer Shift Actuator Assembly) |
OK
NG