This circuit detects the ignition switch is ACC or off, and sends this information to the main body ECU (multiplex network body ECU).
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Read the Data List according to the display on the GTS.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM (except 5L-E)>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ACC SW | Ignition switch signal / OFF or ON | OFF: Ignition switch off
ON: Ignition switch ACC |
"ON" is also displayed for this item when the ignition switch is ON. |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the driver side junction block assembly connectors.
| *a | Front view of wire harness connector
(to Driver Side Junction Block Assembly) |
- | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2K-1 - Body ground | Always | 11 to 14 V |
| 2O-23 - Body ground | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2N-1 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
| *a | Component without harness connected
(Driver Side Junction Block Assembly) |
- | - |
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2K-1 - A-30 (ACC) | Battery not connected to 2O-23 and 2N-1 | 10 kΩ or higher |
| Battery positive (+) → 2O-23
Battery negative (-) → 2N-1 |
Below 1 Ω | |
| 2N-1 - A-11 (GND1) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG