When the combination switch assembly (ECO mode switch) is turned on, the air conditioning amplifier assembly receives a combination switch assembly (ECO mode switch) ON signal and controls the air conditioning to enhance fuel efficiency.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ECO Switch | ECO mode switch / ON or OFF | ON: ECO mode switch on
OFF: ECO mode switch off |
- |
Combination switch assembly (ECO mode switch) condition displayed on the GTS changes with the actual switch operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the combination switch assembly (ECO mode switch).
Click hereDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>COMBINATION SWITCH>REMOVAL
Inspect the combination switch assembly (ECO mode switch).
Click hereVehicle Interior>HEATING / AIR CONDITIONING>ECO SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G24 air conditioning amplifier assembly connector.
Disconnect the G303 shift position indicator connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G303-14 (ECU) - G24-18 (ECOS) | Always | Below 1 Ω |
| G303-18 (E) - Body ground | Always | Below 1 Ω |
| G303-14 (ECU) or G24-18 (ECOS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the shift position indicator with a known good one (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Automatic Transmission)>DISASSEMBLY).
Check that the malfunction disappears.
Malfunction disappears.
| Proceed to |
|---|
| OK |
| NG |
OK
NG