Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67910
2.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
62111C
3.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL
55607
4.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62311B
5.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Remove the front door opening trim weatherstrip RH in the range shown in the illustration.
55317A
6.REMOVE INSTRUMENT SIDE PANEL RH
55461A
7.REMOVE INSTRUMENT PANEL ORNAMENT
55550
8.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
87201B
9.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
85940
10.REMOVE WINDSHIELD WIPER RELAY ASSEMBLY (for LHD, w/ Auto Wiper)
86740
11.REMOVE TELEPHONE TRANSCEIVER ASSEMBLY (for LHD, w/ Telematics Transceiver, w/o Double Door Lock)
86740
12.REMOVE TELEPHONE TRANSCEIVER ASSEMBLY WITH DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY (for LHD, w/ Telematics Transceiver, w/ Double Door Lock)
|
Bolt |
|
Nut |
|
Connector |
Remove the bolt and nut.
Disconnect the 4 connectors and remove the telephone transceiver assembly with double lock door control relay assembly.
82877
13.REMOVE ECU INTEGRATION BOX RH (for LHD)
Disconnect the 9 connectors.
Detach the 2 clamps.
|
Bolt |
|
Nut |
Remove the 2 nuts, bolt and ECU integration box RH.
82878
14.REMOVE ECU INTEGRATION BOX LH (for RHD)
Disconnect the 9 connectors.
Detach the 2 clamps.
|
Bolt |
|
Nut |
Remove the 2 nuts, bolt and ECU integration box LH.
88650N
15.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
| *A | for LHD |
| *B | for RHD |
Detach the 2 claws and remove the air conditioner amplifier assembly.