When the volume of washer fluid decreases to below a certain level (when the level warning switch assembly is turned on), the multi-information display warns the driver by displaying a message*1 or the combination meter assembly warns the driver by displaying a washer fluid warning light*2.
*1: w/ Multi-information Display
*2: w/o Multi-information Display
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Use the Data List to check if the level warning switch assembly is functioning properly (See page Vehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Washer Switch | Level warning switch / ON or OFF | ON: Fluid volume is less than 550 to 750 cc (33.5 to 45.7 cu.in.)
OFF: Fluid volume is more than 550 to 750 cc (33.5 to 45.7 cu.in.) |
- |
On GTS screen, item changes between ON and OFF according to above chart.
OK
NG
Remove the level warning switch assembly (See page Vehicle Exterior>WIPER / WASHER>WASHER LEVEL WARNING SWITCH>REMOVAL).
Inspect the level warning switch assembly (See page Vehicle Exterior>WIPER / WASHER>WASHER LEVEL WARNING SWITCH>INSPECTION)
OK
NG
Disconnect the A23 and B washer wiring assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A23-3 (S) - B-1 | Always | Below 1 Ω |
| A23-6 (E) - B-2 | Always | Below 1 Ω |
| A23-3 (S) or B-1 - Body ground | Always | 10 kΩ or higher |
| A23-6 (E) or B-2 - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the A23 washer wiring assembly connector.
Disconnect the G304 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A23-3 (S) - G304-30 (WLVL) | Always | Below 1 Ω |
| A23-6 (E) - Body ground | Always | Below 1 Ω |
| A23-3 (S) or G304-30 (WLVL) - Body ground | Always | 10 kΩ or higher |
OK
NG