Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL ACTUATOR › 2017.08–2020.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260881 ABSORBER CONTROL ACTUATOR A

SUSPENSION CONTROL  ABSORBER CONTROL ACTUATOR  INSTALLATION  


PROCEDURE

Hide 89269A 1.INSTALL SUSPENSION CONTROL BRACKET LH

a.

Using SST, install the bracket with the nut.

SST
09961-00950  

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


Hide 89241B 2.INSTALL ABSORBER CONTROL ACTUATOR LH

a.

Using a hexagon wrench (4 mm), install the absorber control actuator with the 2 hexagon socket head cap bolts.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Replace the absorber control actuator with a new one if it is dropped.



b.

Connect the connector, and then attach the 3 clamps.

NOTICE:

Securely connect the connector.



Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).