Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type) › 2017.08–2020.08
RM27T0E _56 Audio / Visual / Telematics _053720 AUDIO / VIDEO _0260969 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the audio and visual system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
·

When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points in problem analysis:

What Vehicle model, system name
When Date, time, occurrence frequency
Where Road conditions
Under what conditions? Driving conditions, weather conditions
How did it happen? Problem symptoms


Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, recharge or replace the battery.



Result:
Proceed to
NEXT



NEXT

4.CHECK CABIN
4.CHECK CABIN
a.

Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

OK:

Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.


HINT:
·

A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

·

The audio and visual system may not operate normally when the temperature is -20°C (-4°F) or less, or 65°C (149°F) or higher.




Result:
Proceed to
OK
NG



OK

5.CHECK CAN COMMUNICATION SYSTEM*

NG

SET CABIN TO APPROPRIATE TEMPERATURE

5.CHECK CAN COMMUNICATION SYSTEM*

Result:
Result Proceed to
CAN DTCs are not output A
CAN DTCs are output (w/ Central Gateway ECU) B
CAN DTCs are output (w/o Central Gateway ECU) C



A

6.DTC CLEAR*

B

C

6.DTC CLEAR*

NEXT

7.RECHECK FOR DTC*
7.RECHECK FOR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>DTC CHECK / CLEAR

HINT:
·

Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores past diagnostic trouble codes.

·

After the check using the GTS, check the "System Check Mode" screen as necessary.

·

Check the diagnostic trouble code and inspect the area code indicates.




Result:
Result Proceed to
DTC is output A
DTC is not output B



A

8.DIAGNOSTIC TROUBLE CODE CHART

B

9.PROBLEM SYMPTOMS TABLE
8.DIAGNOSTIC TROUBLE CODE CHART

*1: w/ Rear View Monitor System (for Radio and Display Type)

*2: w/ Rear Seat Entertainment System

*3: w/ Multi-terrain Monitor System

*4: w/ Telematics Transceiver


a.

Find the output code in Diagnostic Trouble Code Chart.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
·

The audio and visual system outputs DTCs for the following systems.

·

When DTCs other than the codes in Diagnostic Trouble Code Chart for the audio and visual system are output, refer to Diagnostic Trouble Code Chart for the following systems.




Result:
Result Proceed to
DTCs for the Audio and Visual System (w/ Radio and Display Type) are output A
DTCs for the Rear View Monitor System (w/ Radio and Display Type) are output*1 B
DTCs for the Rear Seat Entertainment System are output*2 C
DTCs for the multi-terrain monitor system are output.*3 D
DTCs for the telematics system are output.*4 E



A

11.CHECK CIRCUIT

B

C

D

E

9.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B


HINT:

If the symptom does not recur and no DTC is output, perform the symptom reproduction method.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




A

10.CHECK ECU TERMINAL ARRANGEMENT BASED ON MALFUNCTION

B

11.CHECK CIRCUIT
10.CHECK ECU TERMINAL ARRANGEMENT BASED ON MALFUNCTION

NEXT

11.CHECK CIRCUIT
11.CHECK CIRCUIT
a.

Adjust, repair or replace as necessary.


Result:
Proceed to
NEXT



NEXT

12.RECHECK FOR DIAGNOSTIC TROUBLE CODE
12.RECHECK FOR DIAGNOSTIC TROUBLE CODE
a.

After clearing DTCs, recheck for DTCs.


Result:
Proceed to
NEXT



NEXT

13.PERFORM CONFIRMATION TEST
13.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END