Use the following procedure to troubleshoot the multi-terrain monitor system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the engine switch off.
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output (for Navigation Receiver Type) | A |
| CAN DTC is not output (for Radio and Display Type) | B |
| CAN DTC is output | C |
A
B
C
Refer to the navigation system (for Navigation Receiver Type).
| Result | Proceed to |
|---|---|
| Navigation System (for Navigation Receiver Type) is normal | A |
| Navigation System (for Navigation Receiver Type) is abnormal. | B |
A
B
Refer to the audio and visual system (for Radio and Display Type).
| Result | Proceed to |
|---|---|
| Audio and visual system (for Radio and Display Type) is normal | A |
| Audio and visual system (for Radio and Display Type) is abnormal. | B |
A
B
Check for DTCs and note any codes that are output.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
Clear the DTC.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to the Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Data List / Active Test.
Terminals of ECU.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT