1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat)
for LH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type LH Side)>REMOVAL).
for RH Side:
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)>REMOVAL).
64910M
3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
58649C
4.REMOVE MAT SET PLATE COVER
58574A
5.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
62538E
6.REMOVE QUARTER TRIM COVER HOLE LH
58570C
7.REMOVE REAR FLOOR CARPET ASSEMBLY
64725D
8.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64937A
9.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
64712F
10.REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
62596D
11.REMOVE QUARTER TRIM POCKET TRAY
73233
12.REMOVE OUTER LAP BELT ANCHOR COVER
64740C
13.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
62640P
14.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
897B0
15.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
Disconnect the connector.
Remove the bolt and tire pressure warning ECU and receiver.