Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat)
67920
4.REMOVE DOOR SCUFF PLATE ASSEMBLY LH
67910
5.REMOVE DOOR SCUFF PLATE ASSEMBLY RH
Use the same procedure described for the LH side.
62112
6.REMOVE COWL SIDE TRIM BOARD LH
62111C
7.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure described for the LH side.
62312B
8.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62311B
9.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure described for the LH side.
74616C
10.REMOVE FRONT NO. 1 ASSIST GRIP PLUG LH
74615E
11.REMOVE FRONT NO. 1 ASSIST GRIP PLUG RH
Use the same procedure described for the LH side.
74611F
12.REMOVE NO. 1 ASSIST GRIP
62212
13.REMOVE FRONT PILLAR GARNISH LH
62211
14.REMOVE FRONT PILLAR GARNISH RH
Use the same procedure described for the LH side.
64910M
15.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Remove the tonneau cover assembly.
58649C
16.REMOVE MAT SET PLATE COVER
|
Protective tape |
Use the same procedure for all mat set plate covers.
Using a screwdriver, detach the 2 claws and remove the mat set plate cover.
Tape the screwdriver tip before use.
58574A
17.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
Remove the 5 screws.
Detach the 6 claws and remove the rear floor mat rear support plate.
62538E
18.REMOVE QUARTER TRIM COVER HOLE LH
Detach the 2 claws and 2 guides and remove the quarter trim cover hole LH.
62538C
19.REMOVE QUARTER TRIM COVER HOLE RH
Use the same procedure described for the LH side.
58570C
20.REMOVE REAR FLOOR CARPET ASSEMBLY
Remove the rear floor carpet assembly.
64725D
21.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Use the same procedure for the other No. 1 luggage compartment trim hook.
Remove the No. 1 luggage compartment trim hook by turning it clockwise.
64937C
22.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
|
Protective tape |
Use the same procedure for the other tonneau cover holder cap.
Using a screwdriver, detach the 2 claws and remove the tonneau cover holder cap.
Tape the screwdriver tip before use.
64712F
23.REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
|
Protective tape |
Use the same procedure for the other front deck side trim cover.
Using a screwdriver, detach the 2 claws and remove the front deck side trim cover.
Tape the screwdriver tip before use.
62596D
24.REMOVE QUARTER TRIM POCKET TRAY
|
Protective tape |
Put protective tape around the quarter trim pocket tray.
Using a screwdriver, detach the 6 claws and 2 guides, and remove the quarter trim pocket tray.
Tape the screwdriver tip before use.
73233
25.REMOVE OUTER LAP BELT ANCHOR COVER
Use the same procedure for the other outer lap belt anchor cover.
Detach the 3 claws and remove the outer lap belt anchor cover.
64740C
26.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips and remove the deck trim side panel assembly LH.
64730B
27.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Remove the bolt and disconnect the front seat outer belt floor anchor.
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips.
Disconnect the connector and remove the deck trim side panel assembly RH.
62520P
28.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
Move the front shoulder belt anchor adjuster to the lowest position.
Remove the bolt.
Detach the 2 clips and 2 guides.
Pass the front seat outer belt floor anchor through the front quarter trim panel assembly LH and remove the front quarter trim panel assembly LH.
62510P
29.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
Use the same procedure described for the LH side.
62640P
30.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
Detach the 7 clips.
Detach the 4 claws and 2 guides, pass the rear No. 1 seat belt floor anchor through the rear quarter trim panel assembly LH and remove the rear quarter trim panel assembly LH.
62630P
31.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY RH
Use the same procedure described for the LH side.
74610A
32.REMOVE ASSIST GRIP SUB-ASSEMBLY
74610U
33.REMOVE REAR ASSIST GRIP ASSEMBLY LH
74610V
34.REMOVE REAR ASSIST GRIP ASSEMBLY RH
Use the same procedure described for the LH side.
81260A
35.REMOVE MAP LIGHT ASSEMBLY
89943
36.REMOVE RAIN SENSOR COVER (w/ Rain Sensor)
87834
37.REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror)
86466E
38.REMOVE NO. 2 FORWARD RECOGNITION COVER (w/ Pre-crash Safety System)
86466D
39.REMOVE NO. 1 FORWARD RECOGNITION COVER (w/ Pre-crash Safety System)
81240
40.REMOVE NO. 1 ROOM LIGHT ASSEMBLY
81240D
41.REMOVE NO. 2 ROOM LIGHT ASSEMBLY
62432B
42.REMOVE NO. 1 ROOF SIDE RAIL GARNISH LH
| *a | Cut Off Position |
Detach the 5 clips.
Cut off the 5 clips and remove the roof side rail garnish LH.
Remove the 5 clips from the vehicle body.
62431B
43.REMOVE NO. 1 ROOF SIDE RAIL GARNISH RH
Use the same procedure described for the LH side.
74318
44.REMOVE VISOR BRACKET COVER LH
74317
45.REMOVE VISOR BRACKET COVER RH
Use the same procedure described for the LH side.
74320
46.REMOVE VISOR ASSEMBLY LH
74310
47.REMOVE VISOR ASSEMBLY RH
Use the same procedure described for the LH side.
74348
48.REMOVE VISOR HOLDER
63310
49.REMOVE ROOF HEADLINING ASSEMBLY
| *A | w/ Camera Heater |
w/ Pre-crash Safety System:
Disconnect the 2 connectors.
w/ Pre-crash Safety System, w/ Camera Heater:
Disconnect the 3 connectors.
w/ EC Mirror:
Disconnect the inner mirror connector.
w/ Rain Sensor:
Disconnect the rain sensor connector.
w/ Sliding Roof:
Disconnect the drive gear connector.
w/ Pre-crash Safety System:
Remove the bolt.
Detach the hook and disconnect the camera earth.
w/ Digital Audio Broadcasting Antenna:
Disconnect the connector and detach the wire harness clamp.
Disconnect the 2 connectors and detach the 3 clamps from the front pillar LH.
Remove the bolt.
Disconnect the 2 connectors and detach the 3 clamps from the front pillar RH.
Disconnect the connector and detach the 3 clamps from the rear pillar LH.
Disconnect the connector and detach the 4 clamps from the rear pillar RH.
w/o Sliding Roof:
Detach the 2 clips.
| *a | Guide |
| *b | Fastener |
w/ Sliding Roof:
Detach the 2 clips, 2 guides and 8 fasteners.
Remove the roof headlining assembly from the back door as shown in the illustration.
Be careful not to damage the roof headlining assembly when removing it.
73024
50.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH
Detach the 4 claws of the front shoulder belt anchor plate sub-assembly LH and slide the front shoulder belt anchor plate sub-assembly LH in the direction of the arrow to remove it.
73023
51.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
66425A
52.REMOVE REAR NO. 2 SIDE RAIL SPACER LH
Remove the clip.
Detach the 4 claws and remove the rear No. 2 side rail spacer LH.
66415A
53.REMOVE REAR NO. 2 SIDE RAIL SPACER RH
Use the same procedure described for the LH side.
64746F
54.REMOVE DECK SIDE TRIM CUP HOLDER LH
Detach the 4 claws and remove the deck side trim cup holder LH.
64745H
55.REMOVE DECK SIDE TRIM CUP HOLDER RH
Use the same procedure described for the LH side.
73372
56.REMOVE REAR SEAT SHOULDER BELT HANGER LH
Detach the claw and guide and remove the rear seat shoulder belt hanger LH.
73371
57.REMOVE REAR SEAT SHOULDER BELT HANGER RH
Use the same procedure described for the LH side.
62627B
58.REMOVE QUARTER TRIM COVER
Use the same procedure for the other quarter trim cover.
Detach the 2 claws and remove the quarter trim cover.
64766B
59.REMOVE QUARTER TRIM JACK COVER (w/ Spare Tire)
Detach the 7 claws and 3 guides and remove the quarter trim jack cover.
64714C
60.REMOVE DECK SIDE TRIM COVER RH (w/o Spare Tire)
Turn the 2 knobs and release the lock.
Detach the 7 claws and 3 guides and remove the deck side trim cover RH.