1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Cold Area Specification Vehicles)
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
53292A
2.REMOVE UPPER RADIATOR SUPPORT SEAL
Remove the 13 clips and upper radiator support seal.
52129B
3.REMOVE FRONT BUMPER LOWER COVER
51405A
4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
5.DRAIN ENGINE COOLANT
52119A
6.REMOVE FRONT BUMPER COVER
52521
7.REMOVE FRONT BUMPER CENTER UPPER RETAINER
53293C
8.REMOVE RADIATOR SIDE DEFLECTOR RH
Using a clip remover, detach the 3 claws and remove the clip. Then move the radiator side deflector RH so that the radiator can be removed in the step below.
53294C
9.REMOVE RADIATOR SIDE DEFLECTOR LH
Using a clip remover, detach the 3 claws and remove the clip. Then move the radiator side deflector LH so that the radiator can be removed in the step below.
17341F
10.REMOVE NO. 1 AIR HOSE
17342F
11.REMOVE INTERCOOLER AIR HOSE
16571C
12.REMOVE NO. 1 RADIATOR HOSE
82123
13.REMOVE NO. 3 ENGINE WIRE (for Cold Area Specification Vehicles)
16711
14.REMOVE FAN SHROUD
16572D
15.DISCONNECT NO. 2 RADIATOR HOSE
Slide the clamp and disconnect the No. 2 radiator hose.
16400
16.REMOVE RADIATOR ASSEMBLY WITH INTERCOOLER ASSEMBLY
Remove the 4 bolts and radiator assembly with intercooler assembly from the radiator support.
Remove the 2 No. 1 radiator support seals from the radiator assembly.
16593
17.REMOVE NO. 1 RADIATOR AIR GUIDE
Remove the 2 bolts and the No. 1 radiator air guide from the radiator assembly with intercooler assembly.
Remove the No. 3 radiator support seal from the No. 1 radiator air guide.
16562
18.REMOVE NO. 2 RADIATOR TO SUPPORT SEAL
17940D
19.REMOVE INTERCOOLER ASSEMBLY
20.REMOVE VACUUM TRANSMITTING PIPE SUB-ASSEMBLY
Detach the 2 clamps and remove the vacuum transmitting pipe sub-assembly from the radiator assembly.
16533B
21.REMOVE NO. 1 RADIATOR SUPPORT
Remove the 2 No. 1 radiator supports from the radiator assembly.
16534
22.REMOVE NO. 2 RADIATOR SUPPORT
Remove the 2 No. 2 radiator supports from the radiator assembly.
16547
23.REMOVE NO. 1 RADIATOR SUPPORT BUSH
Remove the 4 No. 1 radiator support bushes from the radiator assembly.