These DTCs are stored if the parking assist ECU judges as a result of its self check that the signals or signal lines between the parking assist ECU and the rear television camera assembly are not normal.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1622 | An open or short in the rear television camera signal circuit | ·
Harness or connector ·
Rear television camera assembly ·
Parking assist ECU |
When "!" mark is displayed on the navigation receiver assembly*1 or radio and display receiver assembly*2 after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
(See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION).
*1: for Navigation Receiver Type
*2: for Radio and Display Type
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
*1: w/o Tire Carrier
*2: w/ Tire Carrier
Disconnect the I7 parking assist ECU connector.
Disconnect the X10*1 or v3*2 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I7-38 (CV-) - X10-2 (CV-) | Always | Below 1 Ω |
| I7-15 (CV+) - X10-3 (CV+) | Always | Below 1 Ω |
| I7-14 (CB+) - X10-6 (CB+) | Always | Below 1 Ω |
| I7-37 (CGND) - X10-5 (CGND) | Always | Below 1 Ω |
| I7-38 (CV-) or X10-2 (CV-) - Body ground | Always | 10 kΩ or higher |
| I7-15 (CV+) or X10-3 (CV+) - Body ground | Always | 10 kΩ or higher |
| I7-14 (CB+) or X10-6 (CB+) - Body ground | Always | 10 kΩ or higher |
| I7-37 (CGND) or X10-5 (CGND) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I7-38 (CV-) - v3-2 (CV-) | Always | Below 1 Ω |
| I7-15 (CV+) - v3-3 (CV+) | Always | Below 1 Ω |
| I7-14 (CB+) - v3-6 (CB+) | Always | Below 1 Ω |
| I7-37 (CGND) - v3-5 (CGND) | Always | Below 1 Ω |
| I7-38 (CV-) or v3-2 (CV-) - Body ground | Always | 10 kΩ or higher |
| I7-15 (CV+) or v3-3 (CV+) - Body ground | Always | 10 kΩ or higher |
| I7-14 (CB+) or v3-6 (CB+) - Body ground | Always | 10 kΩ or higher |
| I7-37 (CGND) or v3-5 (CGND) - Body ground | Always | 10 kΩ or higher |
OK
NG
| *a | Component without harness connected
(Parking Assist ECU) |
Disconnect the parking assist ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 38 (CV-) - Body ground | Always | Below 1 Ω |
| 37 (CGND) - Body ground | Always | Below 1 Ω |
OK
NG
for LHD:
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU (for LHD)>REMOVAL)
for RHD:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU (for RHD)>REMOVAL
| *a | Component with harness connected
(Parking Assist ECU) |
Disconnect the rear television camera assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| I7-14 (CB+) - I7-37 (CGND) | Engine switch on (IG) | 5.5 to 7.05 V |
| I7-14 (CB+) - I7-37 (CGND) | Engine switch off | Below 1 V |
OK
NG
for LHD:
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU (for LHD)>REMOVAL)
for RHD:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU (for RHD)>REMOVAL
Check the waveform of the rear television camera assembly using an oscilloscope.
| *a | Component with harness connected
(Parking Assist ECU) |
*b | Waveform A |
| *c | Waveform B | *d | Synchronization Signal |
| *e | Video Waveform | - | - |
The video waveform changes according to the image sent by the rear television camera assembly.
| Item | Content |
|---|---|
| Terminal No. (Symbol) | I7-15 (CV+) - I7-37 (CGND) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | ·
Waveform A: Engine switch on (IG), shift lever in R and camera lens is not covered, displaying an image ·
Waveform B: Engine switch on (IG), shift lever in R and camera lens is covered, blacking out the screen |
Waveform is as shown in the illustration.
OK
for LHD:
(See pageAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU (for LHD)>REMOVAL)
for RHD:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU (for RHD)>REMOVAL
NG
w/o Tire Carrier:
w/ Tire Carrier: