When the ignition switch is turned to ON, the center airbag sensor transmits front seat inner belt LH*1 (or RH*2) state signals to the combination meter through the CAN. If the driver side seat belt is not fastened, the combination meter blinks the front seat belt warning light. If the seat belt is fastened, the warning light goes off.
The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.
*1: for LHD
*2: for RHD
Before starting work, wait at least a minute after the ignition switch is turned off and after the cable is disconnected from the negative (-) battery terminal (SRS parts are equipped with a backup power source. If work is started within a minute of turning the ignition switch off and disconnecting the cable from the negative (-) battery terminal, SRS parts may deploy).
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure (See pageVehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING )
Malfunction symptoms of SRS parts are difficult to confirm. DTCs are the most important source of information when troubleshooting. During troubleshooting, always confirm DTCs before disconnecting the cable from the negative (-) battery terminal.
Clear the DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| Airbag system DTC is output | B |
A
B
(See pageVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
Operate the GTS according to the display and select Active Test (See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>DATA LIST / ACTIVE TEST).
| Item | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Driver Side Seat Belt | Front seat belt warning light | ON/OFF | Confirm that the vehicle is stopped and the engine is idling. |
Driver side seat belt warning light condition can be switched by Active Test.
OK
NG
Temporarily replace the center airbag sensor with a new one (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL).
NEXT
Check the front seat belt warning light function (See page Vehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>OPERATION CHECK).
Front seat belt warning light operates normally.
OK
NG