CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
| *A | Main Body ECU (Multiplex Network Body ECU) with 3 connectors | *B | for LHD |
| *C | for RHD | - | - |
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
| *A | Main Body ECU (Multiplex Network Body ECU) with 2 connectors | *B | for LHD |
| *C | for RHD | - | - |
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Connect the driver side junction block assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A-32 (IG) - Body ground | - | Ignition power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| A-31 (BECU) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| A-30 (ACC) - Body ground | - | ACC power supply | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| A-11 (GND1) - Body ground | - | Ground | Always | Below 1 Ω |
Install the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Measure the voltage and check for pulses according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
|
*1: for LHD *2: for RHD *3: for 5 Door *4: w/ Door Control Battery *5: Door control battery not charged *6: Door control battery charging or charged *7: w/ Glass Hatch Opener System *8: w/o Entry and Start System *9: w/ Theft Warning Siren *10: w/ Intrusion Sensor *11: w/ Glass Breakage Sensor *12: w/ Security Horn |
||||
| G218-6 (FLCY) - Body ground | R - Body ground | Front door courtesy light switch assembly LH signal | Front door LH open | Below 1 V |
| Front door LH closed | 11 to 14 V | |||
| G218-27 (FRCY) - Body ground | B - Body ground | Front door courtesy light switch assembly RH signal | Front door RH open | Below 1 V |
| Front door RH closed | 11 to 14 V | |||
| 2N-30 (RCTY) - Body ground*1, *3 | R - Body ground | Rear door courtesy light switch assembly RH signal | Rear door RH open | Below 1 V |
| Rear door RH closed | 11 to 14 V | |||
| 2P-23 (RCTY) - Body ground*2, *3 | R - Body ground | Rear door courtesy light switch assembly RH signal | Rear door RH open | Below 1 V |
| Rear door RH closed | 11 to 14 V | |||
| 2Q-33 (LCTY) - Body ground*1, *3 | V - Body ground | Rear door courtesy light switch assembly LH signal | Rear door LH open | Below 1 V |
| Rear door LH closed | 11 to 14 V | |||
| 2O-15 (LCTY) - Body ground*2, *3 | V - Body ground | Rear door courtesy light switch assembly LH signal | Rear door LH open | Below 1 V |
| Rear door LH closed | 11 to 14 V | |||
| 2Q-27 (BCTY) - Body ground*1 | G - Body ground | Back door courtesy light switch assembly signal | Back door open | Below 1 V |
| Back door close | 11 to 14 V | |||
| 2N-27 (BCTY) - Body ground*2 | G - Body ground | Back door courtesy light switch assembly signal | Back door open | Below 1 V |
| Back door close | 11 to 14 V | |||
| G216-27 (GCTY) - Body ground*7 | V - Body ground | Glass hatch courtesy switch input | Glass hatch open | Below 1 V |
| Glass hatch close | 11 to 14 V | |||
| G218-29 (L2) - Body ground | GR - Body ground | Driver side door key-linked lock input | Driver side door key cylinder in lock position | Below 1 V |
| Ignition switch off, all doors closed and driver side door key cylinder in neutral position | 11 to 14 V | |||
| G218-2 (UL3) - Body ground | LG - Body ground | Driver side door key-linked unlock input | Driver side door key cylinder in unlock position | Below 1 V |
| Ignition switch off, all doors closed and driver side door key cylinder in neutral position | 11 to 14 V | |||
| G216-3 (ACTG) - Body ground*4 | R - Body ground | Collision door lock release signal | Collision door lock release function does not operate | Below 2 V*5
7.3 to 10.1 V*6 |
| Collision door lock release function operates | Below 1 V | |||
| 2N-3 (ACT+) - Body ground | L - Body ground | Door lock motor lock drive output | Driver side door control switch not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Lock side of driver side door control switch pushed, or driver side door key cylinder in lock position | 11 to 14 V | |||
| 2Q-9 (ACT+) - Body ground*1, *3 | L - Body ground | Door lock motor lock drive output | Driver side door control switch not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Lock side of driver side door control switch pushed, or driver side door key cylinder in lock position | 11 to 14 V | |||
| 2P-9 (ACT+) - Body ground*2 | L - Body ground | Door lock motor lock drive output | Driver side door control switch not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Lock side of driver side door control switch pushed, or driver side door key cylinder in lock position | 11 to 14 V | |||
| 2N-4 (ACTD) - Body ground | G - Body ground | Driver side door lock motor unlock drive output | Driver side door control switch not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Unlock side of driver side door control switch pushed, or driver side door key cylinder in unlock position | 11 to 14 V | |||
| 2N-5 (ACT-) - Body ground | W - Body ground | Door lock motor unlock drive output | Driver side door control switch not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Unlock side of driver side door control switch pushed, or driver side door key cylinder in unlock position | 11 to 14 V | |||
| 2Q-8 (ACT-) - Body ground*1, *3 | W - Body ground | Door lock motor unlock drive output | Driver side door control switch not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Unlock side of driver side door control switch pushed, or driver side door key cylinder in unlock position | 11 to 14 V | |||
| 2P-8 (ACT-) - Body ground*2 | W - Body ground | Door lock motor unlock drive output | Driver side door control switch not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Unlock side of driver side door control switch pushed, or driver side door key cylinder in unlock position | 11 to 14 V | |||
| 2O-41 (LSFR) - Body ground | G - Body ground | Front door unlock detection switch RH signal | Front door RH unlocked | Below 1 V |
| Ignition switch off, all doors closed and front door RH locked | 11 to 14 V | |||
| 2N-12 (LSFL) - Body ground | G - Body ground | Front door unlock detection switch LH signal | Front door LH unlocked | Below 1 V |
| Ignition switch off, all doors closed and front door LH locked | 11 to 14 V | |||
| 2Q-26 (LSWL) - Body ground*1, *3 | B - Body ground | Rear door unlock detection switch LH signal | Rear door LH unlocked | Below 1 V |
| Ignition switch off, all doors closed, rear door LH locked | 11 to 14 V | |||
| 2O-38 (LSWL) - Body ground*2, *3 | B - Body ground | Rear door unlock detection switch LH signal | Rear door LH unlocked | Below 1 V |
| Ignition switch off, all doors closed, rear door LH locked | 11 to 14 V | |||
| G216-2 (LSWR) - Body ground*3 | V - Body ground | Rear door unlock detection switch RH signal | Rear door RH unlocked | Below 1 V |
| Ignition switch off, all doors closed, rear door RH locked | 8 to 12 V | |||
| G218-17 (LSWB) - Body ground | SB - Body ground | Back door unlock detection switch signal | Back door unlocked | Below 1 V |
| Ignition switch off, all doors closed, back door locked | 11 to 14 V | |||
| G218-15 (IND) - Body ground*8 | G - Body ground | Security indicator light signal | Security indicator illuminates | 3 to 10 V |
| G218-11 (HCTY) - Body ground | B - Body ground | Engine hood courtesy switch | Engine hood open | Below 1 V |
| Ignition switch off, all doors closed and engine hood closed | 11 to 14 V | |||
| G216-18 (SSCL) - Body ground*9 | G - Body ground | Theft warning siren assembly drive | Theft warning siren assembly sounding (Theft deterrent system is in alarm sounding state) | Pulse generation (Below 1 V ←→ 11 to 14 V) |
| G216-13 (SSW1) - Body ground*10 | L - Body ground | Intrusion sensor cancel switch signal | Intrusion sensor cancel switch on | Below 1 V |
| Intrusion sensor cancel switch off | Pulse generation | |||
| G216-12 (ISIF) - Body ground*10 | SB - Body ground | Intrusion and tilt sensor (theft warning ultrasonic sensor) signal | ·
No moving object detected by sensor ·
Vehicle tilt not detected |
11 to 14 V |
| Theft deterrent system changes from disarmed state to armed preparation state | Pulse generation
(See Waveform 1) |
|||
| G218-7 (GPBS) - Body ground*11 | R - Body ground | Glass breakage sensor signal | Glass breakage sensor normal | Below 2 V |
| Glass breakage sensor malfunctioning | 4.5 to 14 V | |||
| 2M-29 (HORN) - Body ground | G - Body ground | Vehicle horn drive | Vehicle horns sounding (Theft deterrent system is in alarm sounding state) | Pulse generation (Below 1 V ←→ 11 to 14 V) |
| 2M-27 (SH) - Body ground*12 | GR- Body ground | Security horn signal | Security horn sounding (theft warning system in alarm sounding state) | Pulse generation (Below 1 V ←→ 11 to 14 V) |
| Security horn not sounding (theft warning system in armed state) | 11 to 14 V | |||
Using an oscilloscope, check the waveform.
The waveform shown in the illustration is an example for reference only. Noise, chattering, etc. are not shown.
Waveform 1 (Reference)
| *a | IOUT Initial Signal | *b | IOUT Initial Response |
| *c | Approximately 1.0 Second | *d | Initial Diagnosis |
| *e | Approximately 1.0 to 1.6 Seconds | *f | Approximately 0.05 Seconds |
| *g | Approximately 5.5 Seconds | *h | Disarmed State |
| *i | Arming Preparation State | - | - |
| Item | Content |
|---|---|
| Tester Connection | G216-12 (ISIF) - Body ground |
| Tool Setting | 2 V/DIV., 100 ms./DIV. |
| Condition | Theft deterrent system changes from armed preparation state to armed state |