Refer to Brake Warning Light Remains ON (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>Brake Warning Light Remains ON).
Refer to Brake Warning Light Remains ON (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>Brake Warning Light Remains ON).
When replacing the skid control ECU (master cylinder solenoid), perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>CALIBRATION).
Disconnect the A7 skid control ECU (master cylinder solenoid) connector.
Turn the ignition switch to ON.
Check that the brake warning light comes on.
Brake warning light comes on.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
A
B
C
A
B
C
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the condition of the brake warning light by operating the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Brake | Brake Warning Light | ON or OFF | Perform the test with the vehicle stopped and engine idling. |
The warning light turns on when operating the GTS.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)