Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2017.08
RM27T0E _53 Suspension _053710 TIRE PRESSURE MONITORING _0260907 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2198  Initialization Switch Error (for Test Diagnosis)  


DESCRIPTION

During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C2198 Initialization Switch Error (for Test Diagnosis) Test mode procedure is performed.
·

Tire pressure warning reset switch

·

Harness or connector

·

Tire pressure warning ECU and receiver


-

WIRING DIAGRAM

C249283E52
5.458,1 6.073,1.198 0.615,0.198 10 false CLSW 2.24,1.5 3.906,1.833 1.667,0.333 10 false Tire Pressure Warning Reset Switch 3.406,0.896 3.688,1.115 0.281,0.219 10 false 1 2.25,1.365 2.865,1.563 0.615,0.198 10 false G153 5.333,3 6.729,3.385 1.396,0.385 10 false Tire Pressure Warning ECU and Receiver 5.333,2.823 5.948,3.021 0.615,0.198 10 false R41 2.302,0.896 2.917,1.094 0.615,0.198 10 false 2 5.25,0.896 5.5,1.115 0.25,0.219 10 false 3

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registration Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.INSPECT TIRE PRESSURE WARNING RESET SWITCH
a.

Turn the ignition switch off.


b.

Remove the tire pressure warning reset switch.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING RESET SWITCH>REMOVAL


c.

Inspect the tire pressure warning reset switch.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING RESET SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER)

NG

REPLACE TIRE PRESSURE WARNING RESET SWITCH

2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER)
a.

Disconnect the G153 tire pressure warning reset switch connector.


b.

Disconnect the R41 tire pressure warning ECU and receiver connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R41-3 (CLSW) - G153-1 Always Below 1 Ω
R41-3 (CLSW) or G153-1 - Body ground Always 10 kΩ or higher
G153-2 - Body ground Always Below 1 Ω


Result:
Proceed to
OK
NG




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR