1.DRAIN ENGINE COOLANT (w/ Urea SCR System)
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/o Urea SCR System)
17940D
3.REMOVE INTERCOOLER ASSEMBLY (w/ Urea SCR System)
89425
4.REMOVE EXHAUST GAS TEMPERATURE SENSOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
w/ Urea SCR System:
Remove the bolt and disconnect the engine wire from the engine cover bracket.
| *A | w/o Urea SCR System |
| *B | w/ Urea SCR System |
Disconnect the 3 connectors from the 3 exhaust gas temperature sensors.
Remove the nut and disconnect the No. 3 exhaust gas temperature sensor from the No. 1 vacuum pipe.
| *A | w/o Urea SCR System |
| *B | w/ Urea SCR System |
Remove the bolt and open the clamp of the pipe clamp.
Detach the 3 connectors from the pipe clamp.
Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.
Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.
Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.