Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM › 2017.08–2021.06
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260886 KINETIC DYNAMIC SUSPENSION SYSTEM C

SUSPENSION CONTROL  KINETIC DYNAMIC SUSPENSION SYSTEM  C1884/84  Steering Angle Sensor Circuit Malfunction  


DESCRIPTION

The stabilizer control ECU receives steering angle information from the steering sensor via CAN communication.

DTC Code DTC Detection Condition Trouble Area
C1884/84 Either condition is met:
·

The stabilizer control ECU receives an error signal from the steering sensor for 5 seconds.

·

A steering sensor BAT terminal open circuit malfunction signal is continuously received for 5 seconds.


·

Steering sensor

·

Steering sensor circuit

·

Stabilizer control ECU



CAUTION / NOTICE / HINT

HINT:

If DTC U0126/71 and C1884/84 are output at the same time, perform the inspection necessary for the CAN communication system first (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>U0100/71).


PROCEDURE

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for steering sensor malfunction DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.CHECK DTC

B

2.CHECK DTC

b.

Perform a road test.


c.

Check for DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

B

REPLACE STABILIZER CONTROL ECU